>>>>>型號:PR9376/010-011 軸振傳感器

【功能描述】

PR9376/010-011是一種軸振傳感器，通常與前置器一起形成一個振蕩器。

其振幅隨著傳感器探頭與金屬被測物的接近與衰減，衰減的幅度與傳感器和被測物之間的距離成正比。

這種傳感器在出廠前已經使用校準材料進行了線性校準，因此在安裝時不需要再進行校準。

用戶只需要調整傳感器和測量面之間的氣隙，直至從前置器的輸出得到所需信號。

PR9376/010-011傳感器有多種型號和配置可供選擇，以滿足不同的測量需要和環境要求。

它帶有安裝螺紋或矩形安裝法蘭，測量范圍為1mm至20mm。螺紋尺寸也有多種選擇，

包括ф6mm、ф10mm和ф18mm的公制或英制螺紋。此外，根據型號的不同，傳感器還可以選擇不同的電纜類型、長度和接頭方式等。

>>>>>型號:PR9376/010-011 軸振傳感器

【英文介紹】

The PR9376/010-011 is a shaft vibration sensor that is usually combined with a preprocessor to form an oscillator.

The amplitude is proportional to the distance between the sensor and the measured object as the sensor 

probe approaches and attenuates.

This sensor has been linearly calibrated using calibration materials before leaving the factory, so no further 

calibration is required at installation. The user only needs to adjust the air gap between the sensor and the 

measuring surface until the desired signal is obtained from the output of the preprocessor.

The PR9376/010-011 sensor is available in a variety of models and configurations to meet different measurement 

needs and environmental requirements. It comes with mounting threads or rectangular mounting flanges with 

measuring ranges from 1mm to 20mm. There are also a variety of thread sizes available, including the Phi 6mm, 

Phi 10mm, and Phi 18mm metric or imperial threads. In addition, depending on the model, the sensor can also 

choose different cable types, lengths and connector methods.

>>>>>型號:PR9376/010-011 軸振傳感器